Electronic Brick - HC06 Serial Bluetooth Brick
  • Electronic Brick - HC06 Serial Bluetooth Brick
  • Electronic Brick - HC06 Serial Bluetooth Brick
  • Electronic Brick - HC06 Serial Bluetooth Brick
  • Electronic Brick - HC06 Serial Bluetooth Brick
  • Electronic Brick - HC06 Serial Bluetooth Brick
  • Electronic Brick - HC06 Serial Bluetooth Brick

Electronic Brick - HC06 Serial Bluetooth Brick

: COM05024
10,98 €

DESCONTINUADO

Quantidade
Sem Stock


DESCRIÇÃO EM PORTUGUÊS BREVEMENTE DISPONÍVEL

Se tiver alguma dúvida neste produto não hesite em contactar-nos.

*Atenção: as imagens são meramente ilustrativas.

Electronic Brick

 

Yes! We can build electronics projects just as easy as piling bricks. Arduino and community have made the programming much easier than ever before. How about some elixir on hardware part? Maybe it is not yet convenient to make complex interfaces, but we can at least start from the most commonly used modules.

 

By using electronic bricks, you may connect Arduino compatible boards easily with various digital, analog and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like poteniometers, sensors, relays, servos...even buttons, just plug and play. 

 

Each terminal module has buckled port with VCC, GND and Output, which has corresponding port on the sensing board, with a plain 2.54mm dual-female cable you may start playing already. Buckled brick cables are like cement for bricks, make the connections easier, secure and more professional looking.

 

EB

 

Overview

 

This Serial Bluetooth brick is easy to use module compatible with existing Stem Basic Shield. It designs for transparent wireless serial connection setup. Serial port Bluetooth module is fully qualified Bluetooth V2.0+EDR(Enhanced Data Rate) 3Mbps Modulation with complete 2.4GHz radio transceiver and baseband. It uses CSR Bluecore 04-External single chip Bluetooth system with CMOS technology and AFH(Adaptive Frequency Hopping Feature). Hope it will simplify your overall design/development cycle.Connect the + pin to 5v and - pin to GND, TX RX pin connect to the seiral pins.

 

Documents

 

Please visit our wiki page for more info about this product. It will be appreciated if you can help us improve the documents by correcting the errors, adding more demo codes or tutorials.

COM05024