Arduino Uno WiFi
  • Arduino Uno WiFi
  • Arduino Uno WiFi
  • Arduino Uno WiFi
  • Arduino Uno WiFi

Arduino Uno WiFi Rev2 - ABX00021

:ARD02060
56,90 €
preço com IVA incluído

Adicione WiFi aos seus projectos com este Arduino Uno WiFi. Basicamente é como se tratasse de um Arduino UNO Rev3 mas com maior potência: vem com o novo processador de 8 bits da Microchip ( ATMEGA4809 ) e com um sensor inercial (IMU) integrado na placa. Relativamente à ligação WiFi, agora poderá comunicar com maior segurança graças ao novo chip de aceleração criptográfica ECC608.

Quantidade
Últimos artigos em stock

DESCRIÇÃO EM PORTUGUÊS BREVEMENTE DISPONÍVEL

Se tiver alguma dúvida neste produto não hesite em contactar-nos.

*Atenção: as imagens são meramente ilustrativas.

Overview

Add this board to a device and you'll be able to connect it to a WiFi network, using its secure ECC608 crypto chip accelerator. The Arduino Uno WiFi is functionally the same as the Arduino Uno Rev3, but with the addition of WiFi and some other enhancements. It incorporates a brand new 8-bit microprocessor from Microchip and has an onboard IMU (Inertial Measurement Unit).

The Wi-Fi Module is a self-contained SoC with integrated TCP/IP protocol stack that can provide access to a Wi-Fi network, or act as an access point.

The Arduino Uno WiFi has 14 digital input/output pins—5 can be used as PWM outputs with Pin 11 that is not PWM as on the UNO Rev3 —6 analog inputs, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller. Simply connect it to a computer with a USB cable or power it with an AC adapter or battery to get started.

Tech Specs

Microcontroller ATMEGA4809
Operating Voltage 5V
Input Voltage (recommended) 7 - 12V
Input Voltage (limit) 6 - 12V
Digital I/O Pins 14 — 5 Provide PWM Output
PWM Digital I/O Pins 5
Analog Input Pins 6
DC Current per I/O Pin 20 mA
DC Current for 3.3V Pin 50 mA
Flash Memory 48 KB (ATMEGA4809)
SRAM 6,144 B (ATMEGA4809)
EEPROM 256 Bytes (ATMEGA4809)
Clock Speed 16 MHz
LED_BUILTIN 25
Length 68.6 mm
Width 53.4 mm
Weight 25 g

PLEASE NOTE: Pin 11 is not PWM enabled and the connector is wrongly marked on some batches. Available PWM pins are: 3, 5, 6, 9, and 10.

ARD02060

Também poderá gostar