Shield para Fita LED RGB
  • Shield para Fita LED RGB
  • Shield para Fita LED RGB
  • Shield para Fita LED RGB

Shield para Fita LED RGB

:ARD03057
12,80 €
preço com IVA incluído

Controlo de PWM com 3 canais independentes, controlo de 12v ou 5v até 1.5A

Quantidade

DESCRIÇÃO EM PORTUGUÊS BREVEMENTE DISPONÍVEL

Se tiver alguma dúvida neste produto não hesite em contactar-nos.

*Atenção: as imagens são meramente ilustrativas.

DESCRIÇÃO EM PORTUGUÊS BREVEMENTE DISPONÍVEL
Se tiver alguma dúvida neste produto não hesite em contactar-nos
Introduction
 
Want to program your RGB LED strip to be a bit more "rhythmic" or "unpredictive"? This RGB LED Strip Shield contains all the components you need to build a super cool RGB (or other three channel) LED project with your Arduino.
 
The shield has 3 outputs with pulse width modulation. Each can control any 12V load, at up to 3A. The shield has built-in IR receiver which allows the LED strip being controlled by an IR remote controller.  A built-in fuse protects the LED strip from over current or any shortage by any reasons. It cares your hard work.
 
This shield makes it possible to drive about 10 meter length RGB LED Strip with your Arduino processor, which almost require 10Amps(@12V) driving capability.
 
Note: Recommend to connect a 12v power source to the DC adater on the RGB Strip driver shield, which could powering the Arduino also and protect the system from overcurrent by fuse.

 

 
 
Specification
  • Compatible with Arduino Uno，Mega，Romeo, etc
  • Compatible with 12V RGB LED Strip
  • Maximum power: 72W （2A per way）
  • Support IR remote control 
Shipping List
  • RGB LED Strip Driver Sheild   *1
Compatability
 
  • Arduino UNO R2/R3 or compatible
  • Arduino Mega 1280/2560
 
Documents
ARD03057

Também poderá gostar