PA (Nylon) FLASHFORGE Alta Resistência 1Kg 1.75mm - Transparente

:IMP02130
33,90 €
preço com IVA incluído

Este é o filamento Nylon PA de cor natural / transparente produzido pela Flashforge. É um tipo de Nylon incrivelmente resistente, tornando-o perfeito para projetos de engenharia exigentes e e que exisgem elvada resistência. O nylon PA tem uma adesão entre camadas incrivelmente forte, garantindo que suas impressões ficam sem rachadelas, ao mesmo tempo em que é muito flexível quando impressas com paredes finas.

Características de Impressão:

  • Temperatura de Extrusão: 220-260°C
  • Velocidade de extrusão: 60-90mm/s
  • Temperatura da cama (opcional): 80-110°C
Quantidade
Sem Stock


DESCRIÇÃO EM PORTUGUÊS BREVEMENTE DISPONÍVEL

Se tiver alguma dúvida neste produto não hesite em contactar-nos.

*Atenção: as imagens são meramente ilustrativas.

Characteristic

  • 1. Good mechanical strength, impact resistance is 10 times higher than normal filament and elongation at break is 50 times higher than normal filament.
  • 2. It has good corrosion resistance and is resistant to many organic solvents.
  • 3. Good abrasive resistance!
  • 4. Good aging resistance!  

 

Advantages

  • 1. High transparency and 90% light transmission
  • 2. High brightness
  • 3. Temperature resistance suitable for long-term use at 100 ℃
  • 4. Low error rate, standard deviation of diameter ≤0.05mm
  • 5. Wide printing range enabling smooth printing between 220 ~ 260 ℃
  • 6. There is no need to use a heating plate when printing on six small models to improve applicability to printers.  

 

Apps

  • 1. Engineering samples can be used for printing models that require special demand as conditions of use, etc.
  • 2. Can be used for printing transparent, durable household appliances such as hangers, vases, lamp shades, etc.  

 

Parameters

  • 1. Single filament diameter at the moment: 1.75mm type, filament diameter range: 1.70 ~ 1.80mm
  • 2. Recommended printing temperature: 220 ~ 260 ℃.
  • 3. Recommended printing temperature range when printing mini or thin-walled models: 210 ~ 240 ℃. Recommended printing temperature range for printing large models: 240 ~ 250 ℃.
  • 4. Printing speed: 60 ~ 90mm / s.
  • 5. Pressure plate temperature: When printing on models with small surface, the pressure plate (platform) does not need to be heated. For models with large bottom surfaces, the pressure plate should be heated up to 80 ~ 110..
  • 6. Substrate: required!
  • 7. We recommend to use perforated plate instead of heat resistant adhesive tape in order to ensure the integrity and beautiful appearance of printed models and to reduce the possibility of folding.

 

IMP02130

Também poderá gostar