Módulo Serie Wifi ESP8266 ESP-01
- Em promoção!
SparkFun ESP8266 Thing
- -3,00 €
Modulo de comunicação wifi ESP8266 -...
NodeMcu Lua - Placa de...
- Em promoção!
- -1,63 €
Wio Node - ESP8266
ESP32-DEVKITC-32D - PLACA DE...
Quer adicionar a internet ao seu projecto? Este é o módulo ideial com um tamanho super pequeno e a um preço imbatível.
O ESP-12E ESP8266 tem um processador de 80 Mhz, 4MB de memória flash, GPIOS (com funcões de PWM, I2C, SPI,...) e alimentação a 3V3. A particulariedade maior é a possibilidade de ser programado através o Arduino IDE com se fosse uma placa arduino.
DESCRIÇÃO EM PORTUGUÊS BREVEMENTE DISPONÍVEL
Se tiver alguma dúvida neste produto não hesite em contactar-nos.
*Atenção: as imagens são meramente ilustrativas.
As you may have heard, the ESP8266 Serial-to-WiFi chip created by Espressif has seen a wide adoption as a cost-effective solution for IoT and WiFi-capable devices. This tiny-sized System On a Chip (SoC) includes an 80 MHz microcontroller with a full WiFi front-end (both as client and access point) as well as a full TCP/IP stack with DNS. Because the ESP8266 comes only in a tiny surface-mount package (QFN-32), a few different vendors have developed a series of modules named ESP-NN where NN are numbers ranging from 01 to 13.
The ESP8266 ESP-12E in this product listing is currently our recommended module for integrating into your own project PCBs. This module was chosen by the NodeMCU project for their Open-Source DevKit 1.0 hardware. The NodeMCU development team Open-Sourced the hardware design, and after garnering enough interest from users around the ESP-12E module, its manufacturers have submitted for, and successfully passed, FCC certification. This represents one less worry when designing embedded applications using this module (note that the FCC-certified version of the module is sometimes referred to as ESP-12F).
Like all ESP-NN modules, the ESP-12E has a small footprint, and even though its castellated pins make it hard to work with out-of-the-box (e.g., on a breadboard), they make life easy when soldering to a PCB. The module breaks out all the GPIO of the ESP8266, and it includes a visible LED for indicating status. In addition, under the tin can, the ESP-12E a 4MB SPI flash storage IC – typically the Winbond W25Q32FV, and all the necessary components needed for the onboard ESP8266 to operate properly (e.g., crystal, capacitors, resistors). It also includes an onboard antenna with a reasonable range (–70~–80 dBm at 50 feet).
Também poderá gostar