Shield GPS Logger NEO-6M

: ARD03177
€15.28

You would like to turn your Arduino into a position-tracking system, speed-monitoring, altitude-observing and make log of all information? This is the shield! It is based on a NEO-6M GPS Module with 66-channel GPS receiver featuring a MediaTek MT3339 architecture and up to a 10Hz update rate. The GPS module will stream constant position updates over a simple TTL-level serial port, which you can then log to a microSD card and/or use for other purposes.

Quantity

If you have any questions on this product please feel free to contact us.

*Disclaimer: The images are merely illustrative.

This GPS Logger Shield will give to your Arduino access to a GPS module, microSD memory card socket, and all of the other peripherals. You would like to turn your Arduino into a position-tracking system, speed-monitoring, altitude-observing and make log of all information? This is the shield! It is based on a NEO-6M GPS Module with 66-channel GPS receiver featuring a MediaTek MT3339 architecture and up to a 10Hz update rate. The GPS module will stream constant position updates over a simple TTL-level serial port, which you can then log to a microSD card and/or use for other purposes.

Everything on the shield is highly configurable: A switch allows you to select the GPS module's UART interface between either hardware or software ports. The regular GPS pins(RX,TX) can be connected to D0-D7 of your Arduino. The microSD card operates over a hardware SPI port, which should be compatible with most of Arduino layouts. The GPS Logger Shield main voltage supply is taken from the Arduino 5V header pin. This voltage is regulated down to 3.3V, which is supplied to both the GPS module and the microSD card. These two components should consume, about 30mA on average, but they may very occasionally spike to around 100mA.

 

Features:

  • On-Board NEO-6M GPS Module
  • External active GPS antenna design with high receive sensitivity, compatible normal antenna
  • Onboard rechargeable battery enable backup parameters ablity
  • SD memory card socket
  • Standard for Arduino sized shield
  • For Arduino reset button
  • Selectable UART jumper controls serial communications

 

Package Included:

  • 1x NEO-6M GPS Logger Shield
  • 1x GPS Antenna
ARD03177

Related products