• DISCONTINUED
  • New

Gravity: I2C BMP280 Barometer Sensor

:SEN12009
€6.42

This sensor can detect air pressure, temperature and altitude and is Arduino compatible. Compared to the last generation BMP180 barometer sensor, it has a lower power consumption, higher resolution and higher sampling frequency.

If you want to know more about this product, please check the Wiki Page.

If you have any questions on this product please feel free to contact us.

*Disclaimer: The images are merely illustrative.

Introduction

DFRobot presents our new BMP280 barometer sensor. It can detect air pressure, temperature and altitude and is Arduino compatible. Compared to the last generation BMP180 barometer sensor, it has a lower power consumption, higher resolution and higher sampling frequency.

Normally, a barometric pressure sensor is used to measure air pressure and temperature. This module can also measure altitude and story height. With the added combination of an IMU sensor, it also includes GPS navigation for three-dimensional (3D) indoor navigation.

The BMP280 barometer sensor is based on Bosch Piezo-resistive pressure sensor technology. It has high EMC robustness, high accuracy and long term stability. The relative accuracy is ±0.12 hPa, which is equivalent to ±1 m difference in altitude. The operating temperature range for long term stability is 0 ~65 ℃.


Note: Since the sensor is very sensitive, please DO NOT touch the chip.

 

Project 1: Environmental Monitoring System Based on OBLOQ-IoT Module
This product is mainly applied in electronic laboratory to monitor and control indicators such as temperature, humidity, light and dust, and timely upload them to the cloud data space to achieve remote monitoring and control of dehumidifier, air purifier, exhaust fan and dimmable light, etc. in the laboratory.     

Hardware List: 

  1. Arduino Compatible

  2. Gravity: UART OBLOQ – IOT Module (Microsoft Azure)

  3. DHT22 Temperature and Humidity Sensor

  4. Sharp GP2Y1010AU0F Compact optical Dust Sensor

  5. Gravity: i2C BMP280 Barometer Sensor

  6. Gravity: Analog Ambient Light Sensor For Arduino

  7. LCD12864 Shield for Arduino

  8. Quadruple relay module

 

Applications

  1. Enahnced GPS navigation (e.g. time-to-first-fix improvement, dead-reckoning, slope detection)

  2. Indoor navigation (floor detection, elevator detection)

  3. Outdoor navigation, leisure and sports applications

  4. Weather forecast

  5. Health care applications (e.g. spirometry)

  6. Vertical velocity indication (e.g. rise/sink speed)

 

Specification

  1. Operating Voltage: 3.3V/5V

  2. Operating Current: 2.7µA @ 1 Hz sampling frequency

  3. Pressure Measurement Range: 300 ~ 1100 hPa (equivalent to +9000…-500 m above/below sea level)

  4. Relative Accuracy: ±0.12 hPa, equiv. to ±1 m (@25℃)

  5. Temperature Measurement Range: 0 ~65 ℃

  6. Temperature Accuracy: 0.01℃

  7. Operating Temperature range: :-40℃~+85℃

  8. Dimensions: 30 x 22mm/ 1.18 x 0.87”

  9. Interface: Gravity-I2C 4pin

  10. Weight: 12g

 

Documents

 

Shipping List

  1. Gravity: i2C BMP280 Barometer Sensor x1

  2. Gravity I2C 4-Pin Cable x1

 

 

SEN12009

You might also like