If you have any questions on this product please feel free to contact us.
*Disclaimer: The images are merely illustrative.
This module is suitable for 18650 batteries only
This module can be powered or for raspberry pi and sensor at the same time
This module output current up to 2.2A (3A peak)
(This product does not contain 18650 batteries, be careful of the battery positive and negative when install, do not reverse. Please follow the + - direction on the PCB and do not follow the positive and negative directions on the battery holder)
1. With over-charging protection and over-discharge protection
2. Micro USB charging interface
3. Charge current: 600~800mA
4. 1 switches to control the USB output
5. Input voltage: 5 ~ 8V
6. 3V 1A output interface
7. 5V 2.2A output interface
8. LED light, green for full of charge, red for under charging