KEYESTUDIO R3 Breadboard kit For Arduino with dupont wire+LED+resistor+PDF - KS0070

:ARD04032
€22.07

UNO R3 Breadboard kit is a learning kit based on UNO R3 development board. It's equipped with basic elements for ARDUINO experiments, including breadboard, Dupont wires, LEDs, resistors. With this kit, you can perform simple LED experiments, such as LED blinking, LED chasing effect, etc. It is both affordable and portable for your Arduino learning.

Chech here the Wiki page

Quantity
Out-of-Stock


If you have any questions on this product please feel free to contact us.

*Disclaimer: The images are merely illustrative.

KS0070-  (5)

 
 

KEYESTUDIO

fab9541780.jpg3f499f9815.jpg

R3 introduction

 Microcontroller: ATmega328   
 Operating Voltage: 5V   
 Input Voltage (recommended) : 7-12V   
 Input Voltage (limits): 6-20V   
 Digital I/O Pins: 14 (of which 6 provide PWM output)   
 Analog Input Pins: 6   
 DC Current per I/O Pin: 40 mA   
 DC Current for 3.3V Pin: 50 mA   
 Flash Memory: 32 KB (ATmega328) of which 0.5 KB used by bootloader   
 SRAM: 2 KB (ATmega328)   
 EEPROM: 1 KB (ATmega328)   
 Clock Speed: 16 MHz   
 Length: 8.6 mm   
 Width: 53.4 mm   
 Weight: 25 g
 

Kit List:

  • 1x Keyestudio UNO R3 Controller
  • 30x Wires
  • 4x M3*10 Copper Pillar
  • 4x M3*6MM Flat Head
  • 4x M3*6MM Round Head
  • 4x Yellow Button Cap
  • 1x Breadboard
  • 1x Chassis
  • 1x 1-digit LED Segment DIsplay
  • 1x Active Buzzer
  • 1x Passive Buzzer
  • 1x Thermistor
  • 5x 10K Resistor
  • 5x 1K Resistor
  • 8x 220R Resistor
  • 2x Tilt Switch
  • 3x Photoresistor
  • 1x Flame Sensor
  • 1x DHT11 Sensor
  • 1x LM35DZ Sensor
  • 4x Push Button
  • 1x RBG LED
  • 1x Blue LED
  • 1x Yellow LED
  • 1x Red LED
  • 1x Potentiometer
  • 1x USB Cable
ARD04032

You might also like